The ace series of USB3 Vision cameras offer fantastic value. The acA1920-155um is built on the Sony Pregius IMX174 1/1.2" sensor. It offers 2.3 MP (1920 x 1200) resolution with astounding image quality: high quantum efficiency, wide dynamic range, and extremely low noise. Delivering up to 164 frames per second at full resolution, this USB3 camera is even smaller than Basler's GigE models.
This camera has relatively large 5.86 µm pixels. This enables greater light sensitivity, greater depth of field, and demands less performance from a lens. If configured to use its full resolution, it has an image circle of 13.27 mm and a 1" lens is needed. To instead use a lower cost 2/3" lens, simply configure the camera for less resolution. All the following resolutions can use a 2/3" (11 mm) lens: 1500 x 1126, 1200 x 1200, 1634 x 920, 1440 x 1200. These resolutions can deliver frame rates of 176, 166, 214 and 166 fps, respectively.
With USB3 Vision, a single cable is used to apply camera power and to transfer data between this camera and a PC, keeping cable runs to a minimum. An auxiliary connector is provided for terminating the input and output signals – there is a total of four.
The Basler ace provides a full set of features to address a wide range of applications. Pixel data can be output in 8 or 12 bit depth. You may adjust the camera’s black level, gain, area of interest, input debounce, and trigger delay. It features automatic exposure control, pixel binning, horizontal image mirroring, event reporting, sending of test images, and a programmable lookup table. There are also “chunk” features that include a frame counter, time stamp, trigger input counter, and CRC checksum calculator. Note that not all features may be available when using third-party software.
Because this camera is USB3 Vision and GenICam compliant, there are many third party software applications and API’s that are compatible. Basler offers their royalty-free Pylon SDK for 32 and 64 bit Windows and Linux platforms.
|Sensor Resolution:||1920 (h) x 1200 (v) pixels|
|Sensor Size:||13.27 mm (1/1.2")|
|Sensor Model:||Sony IMX174LLJ|
|Frame Rate (full resolution):||164 frames/second|
|Quantum Efficiency:||70.0 %|
|Dark Noise:||6.6 e-|
|Saturation Capacity:||31.7 ke-|
|Dynamic Range:||73.7 dB|
|Signal-to-Noise Ratio:||45.0 dB|
|Test Method:||EMVA 1288|
|Data Interface:||USB3 Vision|
|USB Micro-B Receptacle (Male)||USB 3.0 Only (5 Gbps)||Qty 1|
|Hirose 7mm 6 Pin Receptacle HR10A-7R-6PB (Male)||Qty 1|
Learn about camera specs in our Camera Tech Center.
This camera is warranted by the manufacturer to be free from defects in materials and workmanship under normal use for a period of three (3) years from the date of original factory manufacture. For further information, please refer to the manufacturer's website.
Small quantities of cameras normally stocked by Machine Vision Store may be returned within 30 days, subject to a 20% restocking charge, if original package is unopened and in new condition. Larger quantities are subject to Basler's 40% restocking charge. Open packages may not be returned.
All returns must be pre-authorized by Machine Vision Store and shipped with freight pre-paid. Please contact us to request authorization and instructions. The item's serial number and associated sales order number will be needed.