LTLC9030
Leimac CGNSC-IS-12
Strobe Controller for In-Sight cameras, 12V output
This item has been discontinued. Please contact us for substitutes.This strobe controller is designed for direct connection to the Cognex In-Sight EZ700, In-Sight 7000, and Dataman 300 cameras. Connect the M12 connector to the camera, and the 2-pin connector to a Leimac 12 volt constant voltage light. You're ready to go.
Electrical
| Output Channels: | 1 |
| Control Method: | Voltage Control |
| Output Power: | Up to 10W at 12 VDC |
| Strobe Duration: | 16 - 950 μS |
| Response: | < 10 μS off to on; < 10 μS on to off |
Mechanical
| Size: | 40 x 30 x 20 mm |
| Weight: | 50 g |
Environmental
| Operating Temperature: | 0 to 40 °C |
| Operating Humidity: | 20 - 70% RH (no condensation) |
Connectors
| Camera Cable: | 30 cm cable with M12 4-pin male connector |
| Light Cable: | 30 cm cable with SMP-02V-BC connector |
Loading...
See Resources section below to download drawings.
Please contact us for information about any manufacturer's warranty.
Items configured with options marked NC/NR cannot be canceled or returned. Special order items and open cartons cannot be returned unless defective as covered by the manufacturer's warranty. The return of item quantities exceeding that normally stocked by Machine Vision Store will be subject to a restocking fee. All returns must be pre-authorized by Machine Vision Store and shipped with freight pre-paid. Please contact us to request authorization and instructions.