This compact strobe controller enables cameras to be easily synchronized with Leimac 24 volt lights. Attach one connector to the camera, and the 3-pin SMP connector to the light. Optionally, connect an external signal that will trigger the camera to the terminals provided. Connect this controller to 24 volt power.
The camera's output controls the light. If the output is on, the light will turn on. Your camera software can therefore control the light by toggling the output. To strobe the light, configure the camera to turn its output on while the image sensor is exposed.
Because this controller uses the camera's I/O/P connector, the camera must be powered via USB or PoE.
The image above shows two controllers, each with a different cable set. The cable sets are sold separately -- please see the Accessories tab below. Choose the cable set appropriate for your camera.
Loading...
Electrical
| Output Channels: | 1 |
| Control Method: | Voltage Control |
| Input Power: | 24 VDC +/- 5%, 1.5A or less |
| Output Power: | 24 VDC, 36 W max. |
| Response Time: | On: 1.0 μs or less; Off: 2.0 μs or less |
| Overvoltage Category: | Category I |
Mechanical
| Dimensions: | 40 x 33 x 20.5 mm (excluding connectors) |
| Weight: | 40 g or less (without cables) |
Environmental
| Operating Temperature: | 0 to 40°C |
| Operating Humidity: | 20 to 70% RH, non-condensing |
| Storage Temperature: | -20 to +65°C |
| Storage Humidity: | 20 to 70% RH, non-condensing |
| Vibration Resistance: | 19.6 m/s2 10 to 55 Hz 1 hour in X, Y and Z directions |
| Shock Resistance: | 98 m/s2 half sine wave 3 times in X, Y and Z directions |
Connectors
| I/O Connector: | Weidmüller B2L 3.50 / 06 / 180F SN BK BX |
| Power / Trigger Connector: | Molex 395040004 |
Standards
| Conformance | EMC standard: EN55011 Group1 ClassA, EN61000-6-2; RoHS Directive compliant |
Loading...
See Resources section below to download drawings.
Orders for this item cannot be cancelled, nor returned. (Sorry, but this is the manufacturer's policy.)