Machine Vision Store

This enclosure was designed to protect cameras having a variety of mounting hole patterns. It is small and light enough to be mounted on a robot, yet rugged enough to protect a camera from industrial environments. When correctly installed it meets IP65 / NEMA4 requirements.

The internal camera bracket can be mounted at 0, 90, 180 or 270 degrees for complete control over image orientation.

Three barrel lengths are available. Use the 7" barrel for 2" long lenses, the 8.5" barrel for 3.5" long lenses, or 9.5" barrel for 4.5" long lenses. The space for the lens will vary with the exact camera model you have; measure your lens from the front to the rear of the lens body, excluding mounting threads. Allow extra space for a filter or extension ring as appropriate.

This camera enclosure is constructed of 6061 aluminum with a clear hardcoat anodized finish. Fasteners are 18-8 stainless steel. A cord grip is included. To enable a tight seal, the cord grip is shipped without a hole for cable entry. You will need to mill or drill a hole of the same diameter as your cable.

For maximum optical performance, choose this enclosure with the glass window. Or, if you need something harder to break, configure it with an acrylic window.

An air purge kit is included. If you choose to install it, a curtain of air will flow across the view port helping to keep it free of dust, water and oil mist. If installed, you will of course need to provide a source of filtered clean dry air.

With the optional EEAG804 mounting bracket (sold separately) this enclosure is compatible with our camera, light and sensor mounting system. It is shown in the image above with optional EEAG804 mounting bracket, two BTIS100 mounting clamps, and assorted hardware.

Other options include heater, thermostat, and sun shield.