Integrates a light with Basler camera and camera software
Compatible with ace U and L camears
Controls constant-current LED light
The Basler SLP 121040 strobe controller integrates a Basler camera, camera software, and LED light for a more complete, unified solution.
Light control parameters are exposed through the camera's Genicam parameter tree. (Requires use of Basler ace U or L camera having SLP feature.) The camera forwards relevant parameter data to this strobe controller via a serial interface, then automatically triggers the light when needed.
The SLP strobe controller can be operated in continuous, strobe or overdrive mode. The controller can be be used with most constant-current LED lights, so long as the light's power draw is within specifications. Use caution when setting light parameters, being sure not to exceed the light's current limit.
Electrical
| Lighting modes: | Continuous; Strobe incl. overdrive mode |
| Drive method: | Current control |
| Number of channels: | 1; Daisy chain up to 4 controllers |
| Output current continuous: | 0.05A - 2A |
| Output current overdrive mode: | 10A @200µs pulse width |
| Output voltage range: | 1.5V - 40V |
| Max output power continuous: | 40W |
| Max output power overdrive: | 400W (peak) |
| Pulse width: | 50µs - 5ms |
| Pulse step size: | 10µs |
| Max frequency: | 200Hz |
| Input voltage: | 24V +/-10% |
| Output Channels: | 1 |
| Control Interfaces: | Ethernet Genicam |
| Control Method: | Current Control |
| Input power: | 4 A (100 W max.), depending on light |
Mechanical
| Dimensions: | 89 x 60 x 43.5 mm |
| Weight: | 200 g |
Environmental
| Operating Temperature: | 0–50 °C (32–122 °F) |
| Operating Humidity: | 20–80%, non-condensing |
